Workshop Manual

Table Of Contents
© 02/2010 OBJ_DOKU-21756-001.fm
1/2
6
Torsional vibration damper
TCD 2013 2V W 05-02-01
Removing and installing torsional vibration damper
(V-belt drive)
Standard tools
Removing the torsional vibration damper
Unscrew all screws (1).
Remove the torsional vibration damper.
Visually inspect the components.
1
1
1
© 44436-0
Installing the torsional vibration damper
Mount the torsional vibration damper.
M10x20-12.9
without washer
Tighten screws alternately.
70 Nm
Note installation position.
The holes in the torsional vibration damper
must match the threaded holes in the V-
belt pulley.
Attention!
The following new screws without washers
must be used when the torsional vibration
damper is removed or changed.
See the spare parts documentation.
© 44437-0