Operation Manual

Table Of Contents

Section:

Page:

Engine:

Operating the Engine

4.8 Emergency Operation

4.8.1 Engine Operation by Use of the Emergency Operation Device

In case of failure of the engine operating device (control console or remote control), the engine can

be started and shut down by hand.

The specifications as per sections

4.1 to 4.4. are to be observed here.

To avoid faulty switchings, the lever

at the pressure reducing unit (con-

trol console or remote control) is to

be put in the position shown in

Fig.1.

4.8.1.1 Starting the Engine

Pull out locking device at knurled nut (1) -

Fig. 2 -, and pull lever down. If the engine

does not start after approx. 3 seconds,

repeat starting procedure.

If the engine fails to start after repeated

starting attempts, determine the cause

and remedy.

4-7-01

S/BVM 628

Fig. 2

Fig. 1