Operation Manual

Section:
Page:
Engine:
Operating the Engine
Item Job A B C Reference
6 Fuel system
Clean fuel service tank ●
Top up fuel service tank ●●
Clean fuel filter ●●Job 07.10.01
Test fuel injectors ●●Job 07.08.01
Check oil level in
sealing oil tank ●●
Preheat fuel service tank ●●● Section 6.3
Drain fuel service tank ●●●
Open shut-off valve of
fuel service tank ●●●
Switch on sealing oil pump ●●●
Switch on fuel feed pump as
6+2 bar sealing oil pressure ●●●
has been obtained
Heat separate f uel filter if engine
has been stopped on heavy fuel ●●● Section 6.3
Inserire l’impianto di regolazione
della viscosità. ●●● Section 6.3
Bleed fuel system ●●●Job 07.03.02
7 Lube oil system Switch on standby oil pump
if used for priming pump ●
Top up lube oil
reservoir ●●●
Check level in lube oil
reservoir ●●
Clean lube oil filter ●●● 08.10.01
Switch on priming pump and
keep min. 0,35 bar pressure ●●●
for min. 3 minutes
4
4-0-06
S/BVM 628
© 0883