Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Rubber-type Vibration Damper

Inspection / Reconditioning

0178-34-10 1849

12.01.02 Page 3 of 4

S/BVM 628

Insert damping-disc pair complete with threaded

ring (7) - Fig. 4 - into end plate (1). Fit hex. bolts (20)

provided with Deutz DW 55. Tighten up end plate

and damping-disc pair with hex. nuts (15) (Section

3.5, item 58).

Insert ring (2) - Fig. 5 - and disc (14), observing

markings as per Fig. 1. Bolt up the two damping-disc

pairs and disc (14) by means of hex. bolts (13) -

inserted with Deutz DW 55 - and c/w threaded ring

(7) (Section 3.5, item 59).

Place end plate (1) - Fig. 6 - in position, observing

markings as per Fig. 1. Insert hex. bolts (8) and

fasten with nuts complete with spring lockwashers.

Fit hex. bolts (20), provided with Deutz DW 55. Tigh-

ten up end plate and damping-disc pair with hex.

nuts (15) (Section 3.5, item 58).

Fig. 6

Fig. 5

Fig. 4