Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Dirt Collector

0178-32-10 1866

10.03.02

S/BVM 628

Servicing

Before servicing the dirt collector in the starting air

line, make sure that the shut-off valve on the com-

pressed air receiver is closed.

Daily:

Open shut-off valve (1) on dirt collector and allow

condensation water (if any) to drain off. Then reclose

shut-off valve.

Clean the Sieve

as per Maintenance Schedule.

Job:

Loosen hex. nuts (3) and take out hex. bolts (2). Take

off flange (4) and gasket (5). Remove sieve (6). Clean

sieve with a cleaning agent (e.g. cold cleaner) and

rinse afterwards with fresh water. Then blow out with

compressed air. Renew sieve if damaged. Clean

sealing faces of flange and check gasket (5), rene-

wing if necessary. Centre sieve together with retainer

(8) in flange (4) and introduce assembly into tube (7),

taking care that the sieve also sits in the centring of

tube (7).

Now tighten hex. bolts (2) and hex. nuts (3).

Close shut-off valve (1), if open.

Direction of flow

Tools:

- Standard tools,

- Cleaning agent