Operation Manual

Job Card No.:
Engine:
Filing No.:
Oil Filter Combination
(Backflushing Wire Edge Filter)
0178-15-10 6508
Job:
Removing and refitting wire edge filter element;
cleaning filter chamber.
● Stop engine
● Remove drain plug (3) along with joint washer (2).
● Drain oil.
● Remove back flushing line from filter elements.
● Undo hex. nuts (9) and withdraw element (14)
from filter body.
● Remove square flange gasket (8).
To prevent dirty cleaning fluid from getting
inside the element, close open end with a
cap of 55 mm dia.
● Dip element in diesel fuel, actuate rotary knob (5)
alternately and clean element with the brush.
● Remove cap and blow out element from inside
with filtered compressed air.
If the filter wire is damaged or dented,
renew the element.
● Plug up oil outlet bore (4) in filter body.
● Clean filter chamber. Remove plug after cleaning.
● Insert drain plug (3)along with washer (2).
● Refit filter element (14) with new flange gasket (8)
in filter body.
Introduce filter element (14) in perfectly
horizontal position so that it will not touch
the body.
● Tighten hex. nuts (9).
● Refit back flushing line.
08.09.01 Page 2 of 3
S/BVM 628
© 0193
View at X
Fig. 2 Backflushing oil filter combination
© 51 330 0