Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Oil Filter Combination

(Non-Backflushing Wire Edge Filter)

0178-15-10 6507

● Undo hex. nuts (9) - Fig. 2 - with withdraw edge

filter element (14) from filter body.

● Remove square flange gasket (8).

To prevent dirty cleaning fluid from getting

inside the element, close open end with a

cap of 55 mm dia.

● Dip element in diesel fuel, actuate rotary knob (5)

alternately and clean element with the brush.

● Remove cap and blow out element from inside

with filtered compressed air.

If the filter wire is damaged or dented,

renew the element.

● Plug up oil outlet hole (4) - Fig. 3 - in filter body.

● Clean filter chamber. Remove plug after cleaning.

● Insert drain plug (3) - Fig. 2 - along with washer

(2).

● Refit filter element (14) with new flange gasket (8)

in filter body.

● Tighten hex.nuts (9).

Introduce filter element (14) in perfectly

horizontal position so that it will not be

damaged.

08.09.01 Page 2 of 2

S/BVM 628

Fig. 3 Lube oil outlet hole

Fig. 2 Filter element