Operation Manual

Job Card No.:
Engine:
Filing No.:
Oil Filter Combination
(Non-Backflushing Wire Edge Filter)
0178-15-10 6507
Servicing and Repair
Inserted in the lube oil primary flow is a filter combi-
nation comprising a paper microfilter preceding the
wire edge filter (see also Job 08.10.01).
The wire edge filter can be equipped at option with a
differential pressure warning system which responds
in case of excessive contamination.
Servicing
● Daily
- Turn rotary knob (5) through about 1 1/2 turns.
Repeat this procedure on each edge filter
element.
● Clean filter chamber and wire edge filter element:
- 10 running hours after engine overhaul;
- if resistance is felt when turning at the rotary
knob;
- when differential pressure alarm is given.
Remove wire edge filter element only if
absolutely necessary.
Repair
Renew wire edge filter element:
● at the intervals given in the maintenance chart;
● whenever the wire edge filter element is dama-
ged.
Job
Removing and refitting wire edge filter element;
cleaning filter chamber.
● Stop engine
● Remove drain plug (3) along with joint washer (2).
● Drain oil.
© 0193
08.09.01 Page 1 of 2
S/BVM 628
Fig. 1 Non-backflushing oil filter combination
Tools:
- Standard tools
Aids:
- Pail
- Cleaning brush
- Diesel fuel
Job Card:
- 08.10.01
© 50 661 1