Operation Manual

Job Card No.:
Engine:
Filing No.:
Lube Oil Change
0178-15-10 1166
For the above reasons, the manufacturer is
unable to state standard times for lube oil
change. The lube oil should be changed if, on
the basis of oil examinations (see Job Card
08.01.01), there is any doubt regarding the
further usability of the oil.
Lube oil recommendations, dependent on fuel used and engine application, are given in Section 6.
Job:
With engine in hot condition, check that valves are properly positioned and drain oil from sump or extra tank,
using the priming pump as required.
After opening drain and bleed holes, drain oil from filters, cooler and all piping.
Change paper microfilter (job. 08.10.01). Clean crankcase interior and oil tanks, as required.
For filling in the fresh oil, close all drain and bleed holes, fill in oil to top mark and bleed filters, etc., in the
direction of flow. Check oil level while the engine is running and top up as required.
Make sure all piping is tight.
08.02.02
S/BVM 628
© 0185
Oil Change
The oil change period largely depends on the quality
of the fuel and lube oil used, the quantity of oil in the
engine lubrication system, the operating conditions,
the lube oil consumption of the engine, and the
efficiency of the filter.
Job Cards:
- 08.00.01
- 08.01.01
- 08.02.01
- 08.10.01
Tools:
- Standard tools