Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Injection Piping

Renewal

0178-21-10 2057

07.03.03

S/BVM 628

Fig. 1

Fig. 2

Reconditioning

If, due to frequent reassembly or excessive tighte-

ning, the end of the injection piping has been con-

tracted, i.e. the inside diameter is less than 3.0mm,

the piping must be renewed.

Job

Remove injection piping (job 07.03.01).

Screw off clamping sleeves (14) at both ends of the

piping by means of socket spanner (5) - Fig. 1.

Left-hand thread

Withdraw union nuts (2 and 3) from piping - Fig. 2.

Undo fully cap screw (1). Renew O-seals (15 and 16),

as well as clamping sleeves (14).

Assemble new injection piping in the reverse order

with screwed union fittings and mount as described

for job 07.03.01.

Job Card:

- 07.03.01

Tools:

- Standard tools

- Socket spanner with tommy bar

(Section 1.8)