Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Injection Pump Element

Removal / Refitment

0178-17-10 1953

07.02.01 Page 3 of 3

S/BVM 628

Then complete assembly device with bush (7) - Fig. 5

- and fit element seal into position.

Place on bush so that locking strip (299) - Fig.

2 - can engage in the cut-out during reassem-

bly.

Secure bridge (301) - Fig. 2 -, locking strip (299) and

plate (298) by means of screws (303) complete with

washers (348).

Refitting the Delivery Valve

Refitment is carried out in the reverse order as des-

cribed for ”Removing the Delivery Valve”.

Finally, tighten screws (352) - Fig. 1 - as prescribed

(Section 3.5, item 11).

A tightening torque exceeding that quoted is

not permissible and will have no remedial ef-

fect for curing any leaks which may occur.

Mount injection pump cover (1) - Fig. 1 - complete

with gasket.

Mount injection lines (Job Card 07.03.01).

Fig. 5