Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Charge Air System

0178-87-10 1133

06.02.01

S/BV 6/8/9 M 628

Inspection

When a piston is overhauled, inspect charge air

piping inside and clean as necessary.

If the water detector in the charge air pipe

gives an alarm check charge air cooler (2) for

leaks.

Job:

Remove covers (3) and (4). For removal of the latter

loosen bolts (5) and tilt cover.

Inspect pipe inside.

When cleaning the pipe, be sure no dirt or detergents

will find ingress into the cylinder head inlet.

Refit cover (3) with new gasket (6) and cover (4) with

O-seal (7).

If seal (7) is defective, replace. Install seal with a coat

of Deutz F5 compound.

Check that bolts securing charge air cooler to brak-

ket and bolts (8) securing charge air pipe to cylinder

heads are tight.

Fig. 3

Fig. 2

Fig. 1

Tools:

- Standard tools

- „Deutz F5“ (Section 3.6)