Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Exhaust Manifold

0178-41-10 1999

06.01.01 Page 3 of 3

S/BV 9 M 628

Mount fillers at the ends of the exhaust manifold sections as per Fig. 4.

The marking groove is always situated opposite to the exhaust inlet of the upper cross pipe of the T-

shaped exhaust bend, as shown.

Bolting subjected to thermal stressing are to be treated with Deutz S1 compound to facilitate

dismantling work. To do this, clean boltings thoroughly, then apply thin coat of compound using brush,

or, if available, by a spraying can.

Fig. 3