Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Exhaust Manifold

0178-41-10 1986

06.01.01 Page 3 of 3

S/BV 8 M 628

Fig. 4

Boltings of the exhaust gas system which are subject to thermal stress loads have to be coated with

protective lubricating compound ”Deutz S1” to facilitate later dismantling. To do this, clean boltings

thoroughly, then apply thin coat of compound using brush, or, if available, a spray can.

Mount fillers at the ends of the exhaust manifold sections as per Fig. 4.

The marking groove is always situated opposite to the exhaust inlet of the upper cross pipe of the T-

shaped exhaust bend, as shown.