Operation Manual

Control Linkage
0178-29-10 2004
Job Card No.:
Engine:
Filing No.::
Reconditioning Telescopic Pieces
Dismantle link rod C1 - Fig. 1 - as described under ”Inspecting Telescopic Piece”.
Loosen hex. nuts (15) - Fig. 7 - and remove link heads (16) and (10), the latter together with turnbuckle (14).
Carefully screw off union nut (4), which is under pressure of compression spring (9) inside the telescope. Take
out connecting piece (7) and compression spring (9).
Clean all parts in diesel fuel and check for wear and corrosion, renewing any damaged parts.
When re-assembling the telescopic piece (1), fit a new packing ring (6) - wetted completely on the outside with
Deutz DW 48 - in the union nut (4). Apply a coating of Deutz S2 to the sliding surfaces between telescopic
piece (1) and connection piece (7). Completely coat thread of telescopic piece with Deutz DW 60 for receiving
union nut (4). Now insert compression spring (9). Fit union nut over connecting piece (7), screw onto
telescopic piece (1), and tighten.
Mount the link heads in reverse order as for removal. Check function of telescopic piece as described under
”Inspecting Telescopic Piece”.
Check and set the linkage as per Job Card 05.04.14. Lead-seal hex. nuts (15). Mount linkage as described
under ”Inspecting Telescopic Piece”.
Upon completion of the work, check control linkage in mounted condition for proper operation.
05.04.15 Page 5 of 5
S/BV 6/8/9 M 628
© 0199
Fig. 7 Reconditioning of the telescopic pieces
© 50 073 1