Operation Manual

Table Of Contents

Control Linkage

0178-29-10 2004

Job Card No.:

Engine:

Filing No.:

05.04.15 Page 4 of 5

S/BV 6/8/9 M 628

Renewing Link Bearings of Bearing Block (2) -

Fig. 1 -

Release link rods C1 and C3 - Fig. 6 - at the levers (5),

as described under ”Renewing Link Heads”. Unlock

hex. bolts (7) and remove.

Take off levers (5) and Woodruff keys (6). Remove

Allen-head screws (43), take off bearing block. Care-

fully drive out shaft (44) with brass drift and remove

link bearings (3). Clean all parts in diesel fuel and rub

dry with a non-fraying cloth.

First, push one link bearing onto shaft (44) as far as

the stop, after having applied a film of locking com-

pound DW 57 to the seat of the inner ring and to the

seat of the outer ring.

The sliding surfaces of the links must be abso-

lutely free of locking compound.

Push shaft with link bearing into bearing block. Then

fit the second link bearing in similar manner, provi-

ded with Deutz DW 57, and push on as far as the

stop.

When the locking compound has hardened, check

shaft for ease of movement.

Position the two levers (5) together with the Woodruff

keys (6) and push on to butt against the link bearings

(3), free of axial play. Screw in hex. bolts (7), tighten

and lock with locking plates.

Fasten link rods C1 and C3 to levers (5) as described

under ”Renewing Link Heads”.

Fig. 6 Link bearings of bearing block