Operation Manual

Table Of Contents

Control Linkage

0178-29-10 2004

Job Card No.:

Engine:

Filing No.::

Loosen hex. nuts (13) and (15) - Fig. 4 - and turn out

link heads (10) and (16).

Parts (10) and (13) have left-hand threads.

Clean all parts in diesel fuel. Fit new heads and

reassemble link rods in the reverse order. Check and

set linkage as per job card 05.04.14.

Remount as described under "Inspecting Telescopic

Pieces". Lead-seal hex. nuts (13) and (15).

05.04.15 Page 3 of 5

S/BV 6/8/9 M 628

Fig. 4 Heads of links

Fig. 5 Heads of the telescopic piece

Renewing Heads of Link C2 - Fig. 1 -

Dismantling procedure is analogous to that descri-

bed under "Inspecting Telescopic Pieces".

Loosen hex. nuts (13) - Fig. 5 - and (15) and turn out

link heads (10) and (16).

Parts (10) and (13) have left-hand threads

Clean all parts in diesel fuel. Fit new link heads,

check and set linkage as per job card 05.04.14.

Refitting procedure is analogous to that described

under "Inspecting Telescopic Pieces". Lead-seal

hex. nuts (13) and (15).