Operation Manual

Table Of Contents

Control Linkage

0178-29-10 2004

Job Card No.:

Engine:

Filing No.:

Reconditioning

Renewing Heads of Links C3 - Fig. 1 -

Release locking plates of the two fitted hex. bolts (*)

- Fig. 3 - and remove the bolts. Take link rod C3 out

of the forks.

05.04.15 Page 2 of 5

S/BV 6/8/9 M 628

Inspecting Telescopic Piece C1(Fig. 1)

Undo fitted hex. bolt (*) - Fig. 2 -. At the other end of

the link, release locking plate and screw out fitted

hex. bolt. Take link rod out of forked lever, compress

by hand, and release. The resistance thereby occur-

ring should result solely from the compression spring

inside the telescopic piece (1) - Fig. 1 -. The link rod

should then return to its original position.

If not, the telescopic piece must be reconditioned.

Reassembly is in the reverse order, the fitted hex.

bolt (*) - Fig. 2 - then being inserted with locking

compound Deutz DW 57.

The sliding surface of the link ends (**) must be

absolutely free of locking compound.

At the other end of the link rod, secure the fitted hex.

bolt with a new locking plate.

Fig. 2 Telescopic piece

Fig. 3 Linkrod