Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Barber-Colman plus 8 Electronic Governor Linkage

Setting

0178-29-10 1811

Fig. 19

14. After the engine has been put back to service and final load setting has been made, check that the

governor scale gives the following readings:

No load = 9° rotation measured from

Full load = 34° rotation Stop position

Failing this, adjust linkage (points C8 or C10 under 11.).

15. Setting the starting fuel limit:

While the engine is running at 11 bar b.m.e.p.,

pressurize air cylinder of fuel limit and adjust

refitted lever so that there is contact at point

(**) - Fig. 19 - . Tighten screw (*), depressurize

air cylinder.

After finally completing the settings, refit the

covers at points A22, A25, A23 and A26 - Fig.

1 -, together with new gaskets, if necessary.

Remount the linkage covers.

05.04.14 Page 12 of 12

S/BV 9 M 628