Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Barber-Colman plus 8 Electronic Governor Linkage

Setting

0178-29-10 1811

05.04.14 Page 6 of 12

S/BV 9 M 628

Then, at the right-hand end of the link (*) (points A25, A26), adjust the length of the link by means of the

eccentric (**) so that the control rods contact the check stops without pressure, with the gauges

inserted (see Fig. 7). Insert new cheese-head screws (***) and tighten according to specification, see

"Specification Data", Section 3.5, line 60. If the setting at the right-hand eccentric is insufficient , rectify

at the left-hand eccentric.

Having completed the setting, the cheese-head screws have to be lead-sealed.

7. Remove tools (Fig. 7). Move linkage in the

direction "Stop" until one or more stop screws

abut at points C12, C13 and C14 (Fig. 9).

Fig. 8

Fig. 9