Operation Manual

Section:
Page:
Engine:
Specification Data
© 0685
3.3
3-1-09
S/BV M 628
3.3.4 Arrangement of Electrical Equipment
Measuring point No. as per Function / description of the equipment or
separately supplied list of of the gauge point
measuring points
1.3.1 Fuel supply pressure
1.3.3 Pme monitoring
1.3.4 Full load (overload) monitoring
1.3.7 Fuel rack travel indicator
1.3.8 Monitoring of shielded injection pipings
2.3.1 Speed switch - pressure monitor bridging
2.3.2 Lube oil pressure n < 600 l/min
2.3.3 Lube oil pressure n > 600 l/min
2.3.4 Lube oil pressure
2.3.5 Lube oil temperature
2.3.7 Min. lube oil temperature
2.3.8 Differential pressure lube oil filter
2.3.9 Level - lube oil pan
2.4.1 Lube oil pressure
2.4.6 Lube oil temperature
2.4.8 Seal oil pressure
2.4.10 Lube oil pressure start inhibitor
2.4.11 Level - lube oil pan, stand-by pump ON
2.6.3 Lube oil temperature
3.3.2 Engine jacket water temperature
3.3.3 Engine jacket water pressure, circuit I
3.3.4 Raw water pressure
3.3.5 Min. engine jacket water temperature
3.3.7 Engine jacket water, circuit II
3.3.10 Speed switch - pressure monitor bridging
3.4.4 Engine jacket water temperature
3.6.4 Engine jacket water temperature
4.3.1 Max. charge air temperature
4.3.2 Min. charge air temperature
4.3.3 Water detector in charge air pipe
4.6.2 Charge air temperature
5.4.1 Exhaust gas temperature per cylinder
5.4.3 Exhaust gas temperature after turbine
6.3.1 Failure crankcase monitoring system
6.4.5 Crankcase monitoring system
7.3.1 Starting air pressure
7.3.2 Control air pressure
7.3.3 Malfunction of start air interlock (engine fails to start)
7.3.4 Switch - speed setting output
7.3.5 Switch - speed setting input
7.3.6 Switch - engine remote control unit (BVM)
7.3.6 Control unit indicator, engine-mounted/remote (SBVM)
7.3.9 Signal lamp - remote control ON
7.3.10 3/2 -way valve change-over safeguard