Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Woodward UG8D/UG8L Hydraulic Governor Linkage

Setting

0178-29-10 1808

05.04.14 Page 6 of 12

S/BV 6/8 M 628

Then, at the right-hand end of the link (*) (point A24), adjust the length of the link by means of the

eccentric (**) so that the control rods contact the check stops without pressure, with the gauges

inserted (see Fig. 7). Insert new cheese-head screws according to tightening specification, see

"Specification Data", Section 3.5, line 60. If the setting at the right-hand eccentric is insufficient , rectify

at the left-hand eccentric.

Having completed the setting, the cheese-head screws have to be lead-sealed.

7. Remove tools (Fig. 7). Move linkage in the

direction "Stop" until one or more stop screws

abut at points C12 and C13 (Fig. 9).

Fig. 8

Fig. 9