Operation Manual

Job Card No.:
Engine:
Filing No.:
Pump Chest
Removal / Refitment
0178-14-10 1119
Prior to pump chest removal, remove oil
pump(s) (job 08.04.01), water pump(s) (job
09.07.02), vibration damper (jobs 12.01.01.
and 12.01.02) and piping.
Job
Removing the Chest
Unscrew nuts (5) and take down oil deflector (4).
Unscrew bolts (1) and (6) of chest (3) and bolts (10).
Retain chest by hoist with lugs (12) (Fig. 2).
Since the chest is secured to crankcase and
oil sump by adhesive compound, hold woo-
den block behind chest at the side and care-
fully work loose chest by crowbar, until bushes
(9) are cleared.
Take care not to damage surfaces by crowbar.
Raise chest by hoist from oil sump and lower on
wooden support.
Refitting the Chest
Carefully clean all surfaces, removing pressure
marks carefully by a smooth file or oil stone. Apply
Deutz DW 48 as a continuous bead (11) - Fig. 3 - to all
joint faces, but of no more than 3 mm width.
© 1283
04.14.01 Page 1 of 3
S/BVM 628
Fig. 1
Tools:
- Standard tools
- Deutz DW48 compound (Section 1.8)
- Hoist
- Crowbar
Job Cards:
- 08.04.01
- 09.07.02
- 12.01.01
- 12.01.02
- 04.08.01
© 51 294 0