Operation Manual

Job Card No.:
Engine:
Filing No.:
Engine Timing
0178-10-10 2069
04.05.01 Page 3 of 3
S/BV 6/8/9 M 628
© 0592
Camshaft Removal in Confined Spaces
● Remove camshaft, as described above, towards
driving or free end of engine, until flanged con-
nection moves beyond bearing zone when pulling
our pushing out camshaft; then connection may
be detached.
Secure first half-camshaft against falling
down.
● Remove locking wire (2).
● Turn out cheese-head bolts (1).
● Remove dowel pin (3).
● Pull out half-shaft and place carefully on two
wooden supports.
Secure second half-shaft against falling
down.
● Pull out half-shaft and place carefully on two
wooden supports.
Finishing Work
● Clean all parts with distillate fuel.
● Inspect cam running surfaces; smoothen possi-
ble running marks with oil stone; if necessary,
consult one of our service agencies.
● Unscrew stud (15) from guide plate (6).
● Check guide plate with straight edge for even-
ness and guide roller (7) for wear; renew if neces-
sary.
● Screw studs by hand into guide plate using lok-
king compound DEUTZ DW 55; allow locking
compound to cure.
Fig. 7 Camshaft flange connection
Fig. 8 Camshaft guide roller, guide plate
© 50 523 2
© 50 595 1