Operation Manual

Table Of Contents

Job Card No.:

Engine:

Filing No.:

Cylinder Head

Refitment

0178-08-10 1801

01.09.01 Page 3 of 3

S/BV 6/8/9 M 628

Fit puller screw (19) in exhaust manifold (20) - Fig. 5

- and press off manifold from head until gasket (21)

can be fitted in the gap.

Screw in two bolts (22), so gasket cannot fall out.

Unscrew bolts (19) and securely tighten remaining

bolts (22). Connect air and fuel piping.

Set valve clearance (Job Card 01.01.01). Bring indi-

cator cock in normal position and tighten bolts.

Following functional and lubrication test, fit rocker

chamber cover (Job Card 01.01.01).

When fitting new studs (14) - Fig. 3 - into the

cylinder head, apply Deutz DW 57 locking

compound to stud threads.

After screwing studs (14) in as far as they will

go, tighten through 130 Nm torque.

Close annula r gap between stud shaft and

crankcase with Deutz DW 48 sealing com-

pound.

Fig. 5