Operation Manual

Section:
Page:
Engine:
Maintenance Schedules
8
8-1-07
S/BVM 628
© 0394
8.1.4 Periodic maintenance jobs for engines running < 300 hours / year,
which are exclusively or for the greater part of time in standby mode (DEUTZ minimum require-
ment).
In addition, there exist numerous national and international standards which may also be applied if
they do not restrict the specifications given here.
All fittings, shutoff and control devices of operating media systems as well as of compressed air
piping system shall be maintained according to manufacturer’s specifications.
Ser. Interval: Engine Job Card
No.: Job: ready for or Section
operation ? No.
1 Interval: daily
Checking: Starting air pressure yes
Draining: Dirt trap 10.03.02
2 Interval: weekly
Jobs as under ser. No. 1
Checking: Circulating lube oil level yes 08.02.01
Checking: Fuel level in service tank
Checking: lCoolant level in header tank
Servicing: Draining of the compressed air vessel
Servicing: Draining leak-oil-tank
Inspecting: Engine and operating media piping systems for leaks
3 Interval: every three months
Jobs as under ser. Nos. 1 and 2
Engine test run for 1/2 hour under max possible load (min. 25% load) yes see
Section 4
Checking: Operating data, pressures, temperatures, etc.
and comparing with acceptance test record
- under steady-state conditions
about 1/2 hour after start
- before stopping the engine
Checking: Turbocharger turbine slow-down
Inspecting: Lube oil system 08.02.02
Servicing: Operating wire edge lube oil filter 08.09.01
Checking: Temperature monitors 11.01.01
Checking: Pressure monitors 11.01.02
4 Interval: every six months yes see
Jobs as under ser. Nos. 1 to 3 Section
Analyzing engine coolant yes 6.4