Operation Manual

Section:
Page:
Engine:
Trouble-shooting
Trouble Potential Cause Remedy Section /
Job Card
Fuel feed pump Replace pump 07.11.01
defective
Low charge air pressure Clean pressure charger, 06.12.01
air cleaner and cooler; 06.03.11
eliminate air and exhaust 06.04.02
gas losses
Air in injection system Bleed system 07.03.02
Fuel reduction by Have checked by Deutz
governor as a function
of engine speed,
charge pressure
Injection line restricted Replace injection line 07.03.03
in the area of screwed joint
Engine knocks Piston defective Stop engine immediately,
or seized remove piston and 03.02.01
overhaul; inspect 02.10.01
cylinder linerl
Run engine again Section 4.6
Bearing(s) seized Stop engine; have
crankshaft inspected
for cracks by Deutz
Excessive big-end Measure clearance 02.03.03
bearing clearance Replace bearing 02.04.01
High combustion pressure Take indicator diagram, Section 4.5
of all cylinders check injection timing 07.06.01
High combustion pressure Match pressure to rest 07.06.01
of one cylinder of cylinders. 07.08.01
One cylinder overloaded Check injection pump 07.01.01
Excessive exhaust Inspect thermocouple 11.01.05
temperature of one cylinder and injector; examine 07.08.01
exhaust valve. 01.07.01
Have injection pump
adjusted by Deutz 07.02.01
7
7-0-05
S/BVM 628
© 1283