Workshop Manual
Table Of Contents
- Frontpage
- Table of contents
- Checking the compression pressure
- Mounting engine on assembly block and demounting
- Setting valve clearance
- Removing and installing the rocker arm and rocker arm bracket
- Disassembling, assembling and checking the rocker arm and rocker arm bracket
- Removing and installing cylinder head
- Checking piston overhang
- Removing and installing the crankcase bleeding
- Removing and installing the exhaust line
- Removing and install the charge air line
- Removing and installing the turbocharger
- Removing and installing the intake manifold
- Removing and installing the exhaust gas return valve
- Removing and installing the exhaust gas return pipe
- Removing and installing the exhaust gas collection pipe (Exhaust gas recirculation)
- Removing and installing the lifting magnet (Start amount release)
- Renewing the injection lines
- Removing and installing the fuel injectors
- Removing and installing the lifting magnet (charge air pressure-dependent full load stop)
- Installing and removing charge air pressure-dependent full load stop
- Removing and installing fuel pipes
- Removing and installing the fuel filter console
- Removing and installing the fuel supply pump
- Removing and installing the lubricating oil cooler
- Removing and installing the oil filter console
- Removing and installing the oil pressure switch
- Removing and installing the thermostat (Lubricating oil cooler)
- Removing and installing the control line
- Removing and installing the coolant pump
- Checking the thermostat (in the removed state)
- Removing and installing the thermostat
- Removing and installing the thermostat housing
- Removing and installing temperature transmitter
- Removing and installing the lifting magnet (Engine shutdown)
- Removing and installing the V-belt pulley
- Renew V-belts, check V-belt tension
- Removing and installing the flywheel
- Removing and installing the hydraulic pump
- Removing and installing the generator
- Removing and installing the starter
- Removing and installing the heating plugs
- Removing and installing the glow plug
- 7 Standard tools
- 8 Special tools
© 12/2008 17834-001
1/4
6
D 2011 w Lube oil system
TD 2011 w, TCD 2011 w W 08-16-01
Removing and installing the control line
Commercial available tools – W 07-10-08
– W 08-11-07
Collect leaking operating substances in
suitable vessels and dispose of according
to regulations.
Emptying and filling the engine with opera-
ting media must be carried out according to
the operating manual and the appropriate
documentation of the vehicle/equipment
manufacturer.
Removing control line
z Unscrew hollow screw (1).
z Remove sealing rings (2).
z Remove fuel filter console.
W 07-10-08
z Remove oil filter console.
W 08-11-07
2
1
© 47514-0
z Unscrew hollow screws (1).
z Remove sealing rings (2).
z Remove control line (3).
Collect draining lubricating oil and dispose
of properly.
2
2
2
1
1
3
1
© 47650-0