Workshop Manual
Table Of Contents
- Frontpage
- Table of contents
- Checking the compression pressure
- Mounting engine on assembly block and demounting
- Setting valve clearance
- Removing and installing the rocker arm and rocker arm bracket
- Disassembling, assembling and checking the rocker arm and rocker arm bracket
- Removing and installing cylinder head
- Checking piston overhang
- Removing and installing the crankcase bleeding
- Removing and installing the exhaust line
- Removing and install the charge air line
- Removing and installing the turbocharger
- Removing and installing the intake manifold
- Removing and installing the exhaust gas return valve
- Removing and installing the exhaust gas return pipe
- Removing and installing the exhaust gas collection pipe (Exhaust gas recirculation)
- Removing and installing the lifting magnet (Start amount release)
- Renewing the injection lines
- Removing and installing the fuel injectors
- Removing and installing the lifting magnet (charge air pressure-dependent full load stop)
- Installing and removing charge air pressure-dependent full load stop
- Removing and installing fuel pipes
- Removing and installing the fuel filter console
- Removing and installing the fuel supply pump
- Removing and installing the lubricating oil cooler
- Removing and installing the oil filter console
- Removing and installing the oil pressure switch
- Removing and installing the thermostat (Lubricating oil cooler)
- Removing and installing the control line
- Removing and installing the coolant pump
- Checking the thermostat (in the removed state)
- Removing and installing the thermostat
- Removing and installing the thermostat housing
- Removing and installing temperature transmitter
- Removing and installing the lifting magnet (Engine shutdown)
- Removing and installing the V-belt pulley
- Renew V-belts, check V-belt tension
- Removing and installing the flywheel
- Removing and installing the hydraulic pump
- Removing and installing the generator
- Removing and installing the starter
- Removing and installing the heating plugs
- Removing and installing the glow plug
- 7 Standard tools
- 8 Special tools
© 12/2008 17822-001
2/4
6
Fuel system
TD 2011 w, TCD 2011 wW 07-08-02
z Unscrew lifting magnet (1) with plier insert.
1
© 39387-1
z Remove the O-ring with the disassembly tool.
z Visually inspect the components.
© 47647-0
Installing the charge air-pressure depend-
ent full load stop
z Clean sealing surfaces.
z Mount new O-ring.
z Tighten lifting magnet (1) with plier insert.
10 Nm
1
© 39388-1