Workshop Manual
Table Of Contents
- Frontpage
- Table of contents
- Checking the compression pressure
- Mounting engine on assembly block and demounting
- Setting valve clearance
- Removing and installing the rocker arm and rocker arm bracket
- Disassembling, assembling and checking the rocker arm and rocker arm bracket
- Removing and installing cylinder head
- Checking piston overhang
- Removing and installing the crankcase bleeding
- Removing and installing the exhaust line
- Removing and install the charge air line
- Removing and installing the turbocharger
- Removing and installing the intake manifold
- Removing and installing the exhaust gas return valve
- Removing and installing the exhaust gas return pipe
- Removing and installing the exhaust gas collection pipe (Exhaust gas recirculation)
- Removing and installing the lifting magnet (Start amount release)
- Renewing the injection lines
- Removing and installing the fuel injectors
- Removing and installing the lifting magnet (charge air pressure-dependent full load stop)
- Installing and removing charge air pressure-dependent full load stop
- Removing and installing fuel pipes
- Removing and installing the fuel filter console
- Removing and installing the fuel supply pump
- Removing and installing the lubricating oil cooler
- Removing and installing the oil filter console
- Removing and installing the oil pressure switch
- Removing and installing the thermostat (Lubricating oil cooler)
- Removing and installing the control line
- Removing and installing the coolant pump
- Checking the thermostat (in the removed state)
- Removing and installing the thermostat
- Removing and installing the thermostat housing
- Removing and installing temperature transmitter
- Removing and installing the lifting magnet (Engine shutdown)
- Removing and installing the V-belt pulley
- Renew V-belts, check V-belt tension
- Removing and installing the flywheel
- Removing and installing the hydraulic pump
- Removing and installing the generator
- Removing and installing the starter
- Removing and installing the heating plugs
- Removing and installing the glow plug
- 7 Standard tools
- 8 Special tools
© 12/2008 17819-001
1/6
6
D 2011 w Fuel system
TD 2011 w, TCD 2011 w W 07-03-01
Renewing the injection lines
Commercial available tools:
– Dog wrench. . . . . . . . . . . . . . . . . . . 8018
Special tools:
– Plugs/caps . . . . . . . . . . . . . . . . . 170160
Danger!
Wait 30 seconds after switching off the
engine before working on the fuel system.
Attention!
Pay attention to utmost cleanliness when
working on the fuel system.
Remove residue paint and particles of dirt
before removing.
Clean the respective affected parts care-
fully. Blow damp areas dry with compres-
sed air.
Observe the safety regulations and natio-
nal specifications for handling fuels.
Close all connections immediately after
opening with new, clean plugs/caps.
Do not remove plugs/caps until immedia-
tely before assembling.
Collect leaking operating substances in
suitable vessels and dispose of according
to regulations.
Injection pipes may not be bent.
After all work on the fuel system, it must be
bleeded - see the operation manual, chap-
ter "6 Fuel system“.
Removing injection pipes
z Unscrew lock nuts (1) with dog wrench.
1
© 47653-0