Workshop Manual
Table Of Contents
- Frontpage
- Table of contents
- Checking the compression pressure
- Mounting engine on assembly block and demounting
- Setting valve clearance
- Removing and installing the rocker arm and rocker arm bracket
- Disassembling, assembling and checking the rocker arm and rocker arm bracket
- Removing and installing cylinder head
- Checking piston overhang
- Removing and installing the crankcase bleeding
- Removing and installing the exhaust line
- Removing and install the charge air line
- Removing and installing the turbocharger
- Removing and installing the intake manifold
- Removing and installing the exhaust gas return valve
- Removing and installing the exhaust gas return pipe
- Removing and installing the exhaust gas collection pipe (Exhaust gas recirculation)
- Removing and installing the lifting magnet (Start amount release)
- Renewing the injection lines
- Removing and installing the fuel injectors
- Removing and installing the lifting magnet (charge air pressure-dependent full load stop)
- Installing and removing charge air pressure-dependent full load stop
- Removing and installing fuel pipes
- Removing and installing the fuel filter console
- Removing and installing the fuel supply pump
- Removing and installing the lubricating oil cooler
- Removing and installing the oil filter console
- Removing and installing the oil pressure switch
- Removing and installing the thermostat (Lubricating oil cooler)
- Removing and installing the control line
- Removing and installing the coolant pump
- Checking the thermostat (in the removed state)
- Removing and installing the thermostat
- Removing and installing the thermostat housing
- Removing and installing temperature transmitter
- Removing and installing the lifting magnet (Engine shutdown)
- Removing and installing the V-belt pulley
- Renew V-belts, check V-belt tension
- Removing and installing the flywheel
- Removing and installing the hydraulic pump
- Removing and installing the generator
- Removing and installing the starter
- Removing and installing the heating plugs
- Removing and installing the glow plug
- 7 Standard tools
- 8 Special tools
© 12/2008 17810-001
8/8
6
Exhaust system/Charging
D 2011 wW 06-09-07
Technical Data
Tightening specifications
ID no. Name Screw type Notes / Remark Value
A06 057
Pipe to exhaust gas return valve/cylin-
der head (cooling - intake)
Hollow screw
M12x1.5
29 Nm
A06 062
Exhaust return pipe to exhaust return
valve
M8x65-10.9 20 Nm
A06 063
Exhaust gas collection pipe to
exhaust gas return valve
20 Nm
A06 071
Pipe to crankcase (exhaust gas
return - cooling - return)
Hollow screw
M8x1
12 Nm
A06 072
Pipe to exhaust gas return valve
(exhaust gas return - cooling - return)
Hollow screw
M12x1.5
29 Nm
A06 074
Exhaust gas return pipe to cylinder
head (exhaust gas return)
8.5 Nm
A06 075
Safety cover on sensor housing
(exhaust gas return)
Locking
screw
Torx-Plus
30IPR
8Nm
For the tightening procedure according to torque using a torque wrench, a maximum variation of the
tightening torque of +/- 10% is permissible.