Workshop Manual
Table Of Contents
- Frontpage
- Table of contents
- Checking the compression pressure
- Mounting engine on assembly block and demounting
- Setting valve clearance
- Removing and installing the rocker arm and rocker arm bracket
- Disassembling, assembling and checking the rocker arm and rocker arm bracket
- Removing and installing cylinder head
- Checking piston overhang
- Removing and installing the crankcase bleeding
- Removing and installing the exhaust line
- Removing and install the charge air line
- Removing and installing the turbocharger
- Removing and installing the intake manifold
- Removing and installing the exhaust gas return valve
- Removing and installing the exhaust gas return pipe
- Removing and installing the exhaust gas collection pipe (Exhaust gas recirculation)
- Removing and installing the lifting magnet (Start amount release)
- Renewing the injection lines
- Removing and installing the fuel injectors
- Removing and installing the lifting magnet (charge air pressure-dependent full load stop)
- Installing and removing charge air pressure-dependent full load stop
- Removing and installing fuel pipes
- Removing and installing the fuel filter console
- Removing and installing the fuel supply pump
- Removing and installing the lubricating oil cooler
- Removing and installing the oil filter console
- Removing and installing the oil pressure switch
- Removing and installing the thermostat (Lubricating oil cooler)
- Removing and installing the control line
- Removing and installing the coolant pump
- Checking the thermostat (in the removed state)
- Removing and installing the thermostat
- Removing and installing the thermostat housing
- Removing and installing temperature transmitter
- Removing and installing the lifting magnet (Engine shutdown)
- Removing and installing the V-belt pulley
- Renew V-belts, check V-belt tension
- Removing and installing the flywheel
- Removing and installing the hydraulic pump
- Removing and installing the generator
- Removing and installing the starter
- Removing and installing the heating plugs
- Removing and installing the glow plug
- 7 Standard tools
- 8 Special tools
© 12/2008 17809-001
5/8
6
Exhaust system/Charging
D 2011 w W 06-09-06
z Clean sealing surfaces.
z Mount gasket (1).
z Mount exhaust gas collection pipe (2).
z Fasten screws (3).
z Tighten screws (3).
20 Nm
3
3
2
1
© 46939-1
z Insert pipe (5).
z Mount new sealing rings (4).
z Screw on hollow screw (3).
z Mount sealing rings (2).
z Tighten hollow screw (1).
29 Nm
z Tighten hollow screw (3).
12 Nm
2
5
1
4
3
© 46938-0
z Insert pipe (1).
z Mount sealing rings (2).
z Screw on hollow screw (3).
z Mount new sealing rings (4).
z Turn in hollow screw (5).
z Tighten hollow screw (5).
29 Nm
z Tighten hollow screw (3).
29 Nm
3
1
2
4
5
© 46935-1