Workshop Manual

© 01/2009 OBJ_DOKU-23505-001.fm
1/12
6
D 2011 Fuel system
TD 2011 W 07-04-01
Removing and installing the fuel injector pump
Standard tools
Special tools:
– Ajustable bolt 100710
– Rig pin 101100
– Test template 103040
– Special pliers 103220
– Disassembly tool 110901
– Plugs/caps 170160
– Fitting compound
DEUTZ AP1908
– W 07-03-01
– W 07-06-03
– W 07-06-01
– W 07-10-06
– W 11-00-03
– W 12-01-04
Danger!
Wait 30 seconds after switching off the
engine before working on the fuel system.
Attention!
Pay attention to utmost cleanliness when
working on the fuel system.
Remove residue paint and particles of dirt
before removing.
Clean the respective affected parts
carefully. Blow damp areas dry with com-
pressed air.
Observe the safety regulations and natio-
nal specifications for handling fuels.
Close all connections immediately after
opening with new, clean plugs/caps.
Do not remove plugs/caps until immedia-
tely before assembling.
Collect leaking operating substances in
suitable vessels and dispose of according
to regulations.
After all work on the fuel system, it must be
bleeded - see the operation manual, chap-
ter "6 Fuel system“.
The following work procress is described
for a cylinder as an example.
Removing the fuel injector pump
● Unscrew all screws (1).
● Remove cylinder head cowling (2).
● Remove gasket.
– D 2011 i
● Remove V-belt pulley.
 W 12-01-04
2
1
© 47011-0