Workshop Manual

D 2008/2009
Exhaust system / Charging
W 06-07-03
© 02/2006 6010-001
2/2
6
z Clean sealing surfaces.
© 41089-0
Install intake manifold
z Screw on fuel line (5).
z Coat the screws (2) with fitting compound.
z Mount gasket (4).
z Mount intake manifold (3).
z Tighten screws (2).
 27 Nm
z Tighten pipe clip (1).
Tightening sequence: From the centre out-
wards.
1
2
3
4
5
© 41090-1
z Mount high pressure pipes.
z Screw on union nuts.
z Tighten union nuts.
 28 Nm
z Position pipe clip.
z Tighten screw.
 9 Nm
Attention!
Install injection pipes without tension.
© 41091-0