Workshop Manual

D 2008/2009
Engine control
W 04-05-05
© 02/2006 6008-001
4/6
6
Checking the axial backlash
z Mount magnetic measuring stand.
z Insert dial gauge.
z Apply stylus to the camshaft end with pre-tension.
z Press crankshaft in direction of arrow.
© 41160-1
z Adjust dial gauge to "0".
z Press crankshaft in direction of arrow.
z Read actual value from dial gauge.
z Setpoint :
 0,07 - 0,29 mm
z Remove magnetic measuring stand.
z Remove dial gauge.
The axial backlash is not adjustable.
If the axial backlash is greater than the set-
point, the camshaft must be renewed.
© 41161-1
z Mount camshaft toothed wheel.
z Fasten screw (2).
Mount camshaft toothed wheel with the
bore on the clamping pin (1).
1
2
© 41081-1