Workshop Manual

D 2008/2009
Engine control
W 04-04-09
© 02/2006 6007-001
2/4
6
z Remove screws.
z Remove gearcase cover.
z Clean sealing surfaces.
z Visually inspect sealing surfaces (arrows).
Attention!
Do not damage the sealing surfaces.
© 41053-0
Installing the gearcase cover
z Knock out crankshaft sealing ring (1).
z Clean sealing surfaces.
Attention!
Do not damage sealing surface when
knocking out.
1
© 41054-1
z Fix the new gasket to the crankcase with a little
grease.
Note installation position!
Make sure the clamping bushings (1) are
in place.
1
1
© 41056-0