Workshop Manual

© 02/2006 6001-001
7/10
D 2008/2009
Drive system
W 02-04-01
6
z Install main bearing housing (1).
z Tighten screws (2).
– Step 1:
 15 Nm
– Step 2:
 27 Nm
z Renewing the crankshaft sealing ring.
 W 02-02-02
1
2
© 41038-1
z Check axial backlash of crankshaft.
 W 02-01-04
z Heat up crankshaft toothed wheel to approx. 100 °C.
z Mount crankshaft toothed wheel (1).
z Install oil pressure regulating valve.
 W 08-11-10
Danger!
Danger of burning!
Note installation position of Woodruff
key (2) and groove.
1
2
© 41039-0
z Mount camshaft toothed wheel.
z Fasten screw (2).
Mount camshaft toothed wheel with the
bore on the clamping pin (1).
1
2
© 41065-1