Workshop Manual

D 2008/2009

Drive system

W 02-04-01

6/10

z Dismantle assembly tool.

z Remove assembly tool.

z Check that the lubricating oil bore is in line.

z Check installation depth of the bearing bush with

depth measuring appliance.

 ca. 3 mm

If the lubricating oil bore is not in line, the

bearing bush must be removed and re-

installed.

Installing the crankshaft

z Lightly oil bearing bush (1) with engine oil.

z Push crankshaft into crankcase.

z Insert thrust washers (4) at the rear with grease.

Align screw thread (2) and through

hole (3).

Lubricating oil grooves face the crankshaft.

z Push in the crankshaft in the direction of the arrow to

the stop.

z Tighten locating screws (1).

z Install oil suction pipe.

 W 08-04-06