Workshop Manual
D 2008/2009
Fuel system
W 07-04-01
© 02/2006 6011-001
4/4
6
z Push fuel injector toothed wheel (4) onto fuel injector
shaft.
z Push the measuring pin (3) through the marking hole
into the crankcase.
z Mount washer (2).
z Mount nut (1).
z Tighten nut (1).
10 Nm
Attention!
The marks of the fuel injector toothed
wheels and the idler gear must be in line.
1
2
3
4
© 41147-0
z Loosen blocking screw (1).
z Push locking ring (2) towards smaller opening.
z Tighten blocking screw.
10 Nm
z Tighten nut of fuel injector toothed wheel.
81 Nm
z Remove measuring pin.
Attention!
Loosening the blocking screw releases the
blocking of the fuel injector shaft.
Never start the engine with the fuel injector
shaft blocked!
2
1
© 41143-0
z Mount gearcase cover.
W 04-04-09
z Mount high pressure pipes.
z Screw on union nuts.
z Tighten union nuts.
28 Nm
z Position pipe clip.
z Tighten screw.
9 Nm
Attention!
Install injection pipes without tension.
© 41093-1