Service Manual
Table Of Contents
6
© 2001
● Unscrew hex screw 1.
● Remove outer belt pulley half 2.
● Replace V-belt if necessary.
● In order to retension, remove one or more
inner washers 3. Place the removed wash-
ers on the outside on the removed belt
pulley half 2.
● Tighten screw 1 again. Whilst tightening,
turn engine over simultaneously in order to
prevent crushing the V-belt.
Service and Maintenance 6.5 Belt Drives
After installing new belts, run engine for 15
minutes, then check belt tension.
6.5.6 Tensioning
or changing V-belts
© 24 598 1
© 24 599 1