Workshop Manual
Table Of Contents
- Frontpage
- Table of contents
- Checking the compression pressure
- Mounting engine on assembly block and demounting
- Setting valve clearance
- Removing and installing the rocker arm and rocker arm bracket
- Disassembling, assembling and checking the rocker arm and rocker arm bracket
- Removing and installing cylinder head
- Checking piston overhang
- Removing and installing the crankcase bleeding
- Removing and installing the exhaust line
- Removing and install the charge air line
- Removing and installing the turbocharger
- Removing and installing the intake manifold
- Removing and installing the exhaust gas return valve
- Removing and installing the exhaust gas return pipe
- Removing and installing the exhaust gas collection pipe (Exhaust gas recirculation)
- Removing and installing the lifting magnet (Start amount release)
- Renewing the injection lines
- Removing and installing the fuel injectors
- Removing and installing the lifting magnet (charge air pressure-dependent full load stop)
- Installing and removing charge air pressure-dependent full load stop
- Removing and installing fuel pipes
- Removing and installing the fuel filter console
- Removing and installing the fuel supply pump
- Removing and installing the lubricating oil cooler
- Removing and installing the oil filter console
- Removing and installing the oil pressure switch
- Removing and installing the thermostat (Lubricating oil cooler)
- Removing and installing the control line
- Removing and installing the coolant pump
- Checking the thermostat (in the removed state)
- Removing and installing the thermostat
- Removing and installing the thermostat housing
- Removing and installing temperature transmitter
- Removing and installing the lifting magnet (Engine shutdown)
- Removing and installing the V-belt pulley
- Renew V-belts, check V-belt tension
- Removing and installing the flywheel
- Removing and installing the hydraulic pump
- Removing and installing the generator
- Removing and installing the starter
- Removing and installing the heating plugs
- Removing and installing the glow plug
- 7 Standard tools
- 8 Special tools
© 12/2008 17774-001
2/6
6
D 2011 wCylinder head
TD 2011 w, TCD 2011 wW 01-04-09
– Recess cylinder head
z Insert dial gauge 100410 in measuring beam.
z Place holders (1) on the sealing surface of the crank-
case.
z Place measuring beam (2) on the holders.
z Apply stylus of the dial gauge to the crankcase seal-
ing surface with pre-tension (arrow).
z Adjust dial gauge to "0".
2
11
© 46933-0
z Measure at the points (1) and (2) on the piston.
Schematic representation
2
1
© 34151-2
z Move the measuring beam.
z Apply the stylus to the piston base (arrow) under pre-
tension.
z Continue turning the crankshaft evenly until the re-
versal point of the pointer on the dial gauge is
reached.
The stylus may not be positioned on the
labelling of the piston.
Note greatest measured value.
© 39159-1