Workshop Manual

Drive system
W 02-09-03
0312 1570 - 0138
5/8
© 11/2004
6
2011
Complete the con rod and the piston
z Insert a spring ring.
Note
- The ring joint must face the piston base,
X = +/- 20°
- Pay attention to correct fit of the locking ring
in the groove.
© 39257 0
X
z Insert con rod in piston.
Note
The symbol flywheel/crankshaft (1), on the
piston base, must face left and the numeric
identification (2) on the con rod up.
© 39259 0
1
2
6010
z Oil lightly and press in the piston bolt.
z Insert the second spring ring.
Note
- The ring joint must face the piston
compression bolt.
- Pay attention to correct fit of the spring ring
in the groove.
© 39260 0