Workshop Manual

Cylinder head

W 01-01-01

0312 1555 - 0138

3/4

2011

Setting valve clearance

z Loosen lock nut (1).

z Correct valve clearance by turning the setting

screw (2).

Note

- If valve clearance is too small, unscrew the

setting screw.

- If valve clearance is too great, screw in the

setting screw.

01 61 01 62

z Tighten lock nut (1).

Note

Do not turn the setting screw (2) when

tightening the lock nut.

z Check the valve clearance again with a feeler gauge

blade.

01003

Assembly

z Clean the sealing surface on the cylinder head cover

and cylinder head.

z Fit gasket.

Note

Note installation position, the gate (arrow)

must face the front cover.