Workshop Manual

0312 1645 - 0138
4/6
© 11/2004
5
5 Job card overview
5.2 Sorted numerically
2011
W 03-08-01 Remove and install front cover (opposite side to flywheel) Crankcase
W 03-08-03
Dismantle and complete front cover (speed governor with
torque adaption)
Crankcase
W 03-08-03
Dismantle and complete front cover (speed governor
without torque adaption)
Crankcase
W 03-09-01 Remove and install rear cover (flywheel side) Crankcase
W 03-09-04 Remove and install connection housing Crankcase
W 03-11-01 Remove and install camshaft bearing, check Crankcase
W 04-03-01 Renew camshaft sealing ring (opposite side to flywheel) Engine control
W 04-04-11 Check engine control times Engine control
W 04-04-12
Renew toothed belt and clamping roller (old version of
clamping roller)
Engine control
W 04-04-12
Renew toothed belt and clamping roller (new version of
clamping roller)
Engine control
W 04-05-05 Remove and install camshaft Engine control
W 04-05-06 Check camshaft Engine control
W 05-07-01 Remove and install speed governor Speed governing
W 06-01-05 Remove and install exhaust manifold Exhaust system / Charging
W 06-06-04 Remove and install turbocharger Exhaust system / Charging
W 06-07-03 Remove and install air intake pipe Exhaust system / Charging
W 07-02-06 Remove and install control linkage and guide bushes Fuel system
W 07-02-07 Remove and install lifting magnet for start volume release Fuel system
W 07-03-01 Renew injection lines Fuel system
W 07-04-01 Remove and install injection pumps (Bosch) Fuel system
W 07-04-01 Remove and install injection pumps (Motorpal) Fuel system
W 07-06-03 Determine the thickness of the shim gasket Fuel system
W 07-06-04 Check start of pumping Fuel system
Job card Activity Maintenance group