Workshop Manual

0312 1645 - 0138
3/6
© 11/2004
5
5 Job card overview
5.2 Sorted numerically
2011
Job card Activity Maintenance group
W 00-02-06 Check compression Engine general
W 00-05-01 Assemble and disassemble engine on engine block Engine general
W 01-01-01 Check and set valve clearance Cylinder head
W 01-02-02 Remove and install toggle lever and toggle lever block Cylinder head
W 01-02-06
Disassemble and complete, check toggle lever and toggle
lever block
Cylinder head
W 01-04-04 Remove and install cylinder head Cylinder head
W 01-05-01 Remove and install valves Cylinder head
W 01-05-04 Check valves Cylinder head
W 01-06-03 Check valve guide Cylinder head
I 01-07-07 Machine valve seat ring Cylinder head
W 01-07-08 Check valve lag Cylinder head
W 02-01-07 Check crankcase Drive system
W 02-02-02 Renew crankshaft sealing ring (flywheel side) Drive system
W 02-02-04 Renew crankshaft sealing ring (opposite side to flywheel) Drive system
W 02-03-01 Check con rod Drive system
W 02-03-01 Check con rod (crack con rod) Drive system
W 02-03-03 Remove and install piston bolt bush Drive system
W 02-04-01 Remove and install crankcase Drive system
W 02-09-03 Remove and install pistons and con rod Drive system
W 02-09-03 Remove and install pistons and con rod (crack con rod) Drive system
W 02-09-07 Check piston Drive system
W 02-10-03 Check piston rings and piston ring grooves Drive system
W 02-15-01 Remove and install piston cooling nozzles Drive system
W 03-01-11 Remove and install crankcase bleeding Crankcase
W 03-03-01 Check cylinder Crankcase