Workshop Manual

0312 1644 - 0138

4/6

5 Job card overview

5.1 Sorted alphabetically

2011

Dismantle and complete front cover (speed governor

without torque adaption)

W 03-08-03 Crankcase

Machine valve seat ring I 01-07-07 Cylinder head

Remove and install air intake pipe W 06-07-03

Remove and install cable harness W 13-01-02

Remove and install camshaft W 04-05-05 Engine control

Remove and install camshaft bearing, check W 03-11-01 crankcase

Remove and install charge pressure-depedent full load stop

(LDA)

W 07-08-02 Fuel system

Remove and install connection housing W 03-09-04 crankcase

Remove and install cooling blower W 09-11-01 Cooling system

Remove and install crankcase W 02-04-01 Drive system

Remove and install crankcase bleeding W 03-01-11 crankcase

Remove and install cylinder head W 01-04-04 Cylinder head

Remove and install exhaust manifold W 06-01-05 Exhaust system / Charging

Remove and install flywheel W 12-06-01 Other components

Remove and install front cover (opposite side to flywheel) W 03-08-01 Crankcase

Remove and install fuel filter console W 07-10-08 Fuel system

Remove and install fuel lines (with Bosch injection pumps) W 07-10-06 Fuel system

Remove and install fuel lines (with leak fuel line) W 07-10-06 Fuel system

Remove and install fuel pump W 07-11-01 Fuel system

Remove and install generator (in FL and BFL engines) W 13-02-03

Remove and install generator and holder

(in FM and BFM engines)

W 13-02-03

Remove and install control linkage and guide bushes W 07-02-06 Fuel system

Remove and install helical heater plugs W 13-06-01

Remove and install hydraulic pump W 12-08-02 Other components

Activity Job card Maintenance group

Exhaust system / Charging

Electrical system