Workshop Manual

0312 1643 - 0138
11/14
© 11/2004
4
4 Technical data
4.2 Tightening specifications
2011
08051 Oil cooler fastening screws 21 Nm Torx screw M8
08053 Locking screw thermostat for
injection adjuster on oil filter
console
90 Nm Injection adjustment
08054 Oil cooler connection on
crankcase
13 Nm
• M6 x 60mm
• Hexagon head screw
08061 Transfer nipple on crankcase
(heater connection)
111 ± 11 Nm
• Renew sealing rings
• Note installation position
08062 Locking screws M18 x 1.5 mm at
transfer nipple (heater connection)
50 Nm Renew CU sealing rings
08072 Locking screw oil cooler
thermostat on crankcase
50 Nm Hexagon socket
08091 Oil pressure switch (locking
screw) on crankcase
13 ± 1.5 Nm
Oil pressure switch M10 x
1mm
08093 Oil pressure sensor on crankcase 20 +2 Nm
08094 Locking screw (oil pressure
sensor) on crankcase 50 Nm
• Oil pressure switch / oil
pressure sensor
• M18 x 1.5mm
08095 Oil temperature sensor on
crankcase
25 ± 2.5 Nm
08096 Locking screw (oil temperature
sensor) on crankcase
28 Nm
• Renew CU sealing rings
• Oil temperature sensor
08098 Locking screw (oil pressure
regulating valve) on crankcase
111 Nm
• Renew CU sealing rings
• Oil pressure regulating valve
08099 Locking screw on crankcase
(without air press lubrication)
18 ± 2 Nm
60 ± 6 Nm
80 ± 8 Nm
• M10 x 1mm
• M18 x 1.5mm
• M22 x 1.5mm
ID no. Name
Pre-
tightening
value
Re-tightening
value
Remark