Workshop Manual

0312 1643 - 0138
10/14
© 11/2004
4
4 Technical data
4.2 Tightening specifications
2011
08000 Lube oil system
07095 Charge pressure-dependent full
load stop (LDA) on crankcase
22 Nm
07096 Cap on charge pressure-
dependent full load stop (LDA)
8 Nm
07099 Fuel filter on fuel filter console 9 ± 1 Nm hand tight
ID no. Name
Pre-
tightening
value
Re-tightening
value
Remark
08001 Oil filter
10 -12 Nm
• Oil gasket lightly
• Screw on by hand and screw
tight
08003 Oil filter console on crankcase 21 Nm Torx screw
08010 Lube oil pump on crankcase 22 Nm
08015 Oil suction intake pipe on
crankcase
21 Nm
• Note gasket coating
• Sealant DEUTZ DW 73
08035 Pipe support oil dipstick guide
pipe on oil pump
30 Nm
08042 Oil pressure line on:
• Turbocharger
• Crankcase
29 Nm
• Renew CU sealing rings
• Hollow screw
• Before assembling the line
ATL via pressure oil
connection bore, pre-oil with
approx. 1 cm³ engine oil!
08044 Oil return pipe on turbocharger 40 Nm Screwed socket
Oil return pipe on turbocharger 8.5 Nm Flange socket
08046 Holder for stopper on crankcase 8.5 Nm FL/M engine
Oil return pipe (ATL) holding plate
on crankcase
8.5 Nm BFL/M engines
08047 Oil return pipe (ATL) on crankcase 29 Nm Hollow screw
08048 Oil line to (control line):
• oil filter console
• Crankcase
18 Nm
• Injection adjustment
• Renew CU sealing rings
• Hollow screw
ID no. Name
Pre-
tightening
value
Re-tightening
value
Remark