Workshop Manual

0312 1643 - 0138
5/14
© 11/2004
4
4 Technical data
4.2 Tightening specifications
2011
02000 Drive system
03000 Crankcase
ID no. Name
Pre-
tightening
value
Re-tightening
value
Remark
02010 Main and fit bearing covers on
crankcase 50 Nm
+ 60°
+ 45°
• in case of provability use
max. 3 times
• with lube oil
02015 Crankshaft gear wheel/flange hub
on crankshaft
130 Nm + 210° Central screw
02020 Con rod bearing cover on con rod
(crack con rod) 30 Nm
+ 60°
+ 60°
• tighten alternately
• in case of provability use
max. 5 times
Con rod bearing cover on con rod
30 Nm
+ 60°
+ 60°
in case of provability use
max. 5 times
ID no. Name
Pre-
tightening
value
Re-tightening
value
Remark
03003 Locking screw on crankcase
18 ± 2 Nm
• Setting bolt for crankshaft
lock
• Holder for setting bolt for
crankshaft lock
• Renew CU sealing ring
03004 Locking screw on crankcase
18 Nm
• Setting bolt for control linkage
lock
• Holder for setting bolt for
control linkage lock
• Renew CU sealing ring