Workshop Manual

0312 1630 - 0138

2/4

Other components

W 12-08-02

2011

Install hydraulic pump

z Pull jackets (1 and 2) onto coupling sleeve (3).

Note

The punch-out of the jackets must be aligned

to the teeth of the coupling sleeve.

z Grease the inside teeth of the coupling sleeve with

graphite grease G500.

z Grease the toothed shaft with graphite grease G

500.

z Plug the coupling sleeve (2) to the toothed shaft.

Note

- Note installation position.

- The teeth of the coupling sleeve must

engage the toothed shaft.

z Insert hexagon bolts in the hydraulic pump.

z Check the protrusion of the bolts.

Note

The maximum protrusion ”X” may not be

greater than 18 mm, renew bolts if necessary

or place additional washers under the bolt

head.